Gearench LA16H (3-4 chain) PETOL Bull Tong Manual do Utilizador

Petol Bull Tong LA16H (3-4 chain) Operating Manual Gearench P.O. Box 192 4450 South Highway 6 Clifton, Texas 76634 Phone: (254)

8 Lubrication One of the most important but often-overlooked factors is adequate lubrication. In addition to reducing internal friction, maintainin

9

10 Safety Precautions 1. Always wear safety goggles to protect eyes. 2. Select the right tool for the job. 3. Keep tools in good condition.

Operation The typical application of one Bull Tong is shown in the figure below. Normally an additional tong is used as a backup. The backup tong is

Chain Identification Guide 12

Dimensions 13

14 Torque and Diameter Capacity The following table lists the maximum working torques and the corresponding handle loads for the diameter range of th

15 Chain Selection The following table lists the diameter range of all chain assemblies used with this tong. Chain Min Dia. (inches) Max Dia. (inche

Torque – Handle Load Diagram To use chart: Draw a line from the diameter of the pipe through the desired torque. Read the handle load from the rig

Parts List The following drawings, diagrams, and parts lists describe all parts, which may be needed as replacement items. All tong components are

ii Table of Contents LA16H Petol Bull Tong Description ... 1 Warra

18 Tong Assembly Parts List Item Qty. Part Number Description 1 1 LH16H Handle 2 1 LJ16H Jaw 3 1 HB37 Jaw bolt with nut 4 1 HXN011 Jaw bo

Chain Assembly Parts List Item Part No. Description 1 161-34-02 Special chain only 1 161-34-04 Special chain only 1 161-34-05 Special chain only

1 LA16H Petol Bull Tong Description The Petol Bull Tongs were designed for making up and breaking out casing, drill pipe, and tubular products requi

2 Warranty What Is Covered Gearench tools are expressly warranted to you, the purchaser, to be free of defects in material and workmanship. How Lon

3 Forum Selection Clause Any dispute arising out of the sale and/or use of the GEARENCH tool that is the subject of this limited warranty shall be pr

4 Safe Practices and Procedures Responsibility "It is the responsibility of the employer to train the employee in the proper selection and usage

5 Safety Goggles must always be worn by persons in any area where hand and powered tools are being used. Never apply excess leverage to a wrench or

6 Responsibility of Distributors IT IS THE RESPONSIBILITY OF THE PURCHASERS OF GEARENCH PRODUCTS TO CONVEY THE INFORMATION IN THIS PUBLICATION AND AN

7 Environmental Conditions Wrench chains operate in widely varying environments, from wet outdoor conditions to mildly or highly corrosive industria